Reduction of PEEC unknowns for 3D metallic plates in magnetic shielding

Nenghong Xia, Ya Ping Du

Research output: Journal article publicationJournal articleAcademic researchpeer-review

3 Citations (Scopus)

Abstract

This paper presented the PEEC models for 3D metallic plates with symmetry and/or anti-symmetry. These plates of concern were normally used for magnetic shielding, and were made of either conductive material or linear magnetic material. The distribution of both induced current and magnetization in the plates was examined, and the symmetrical and anti-symmetrical prosperities in typical shielding structures were identified. Reduced system matrix equations were provided. Using the loop analysis technique, the matrix equation can be reduced to one sixth approximately in size if these properties are fully taken into account. A shielding problem can be then solved at the reduced cost without loss of accuracy. The proposed modeling techniques have been tested numerically, and validated with a commercial FEM code.
Original languageEnglish
Article number6514646
Pages (from-to)2001-2004
Number of pages4
JournalIEEE Transactions on Magnetics
Volume49
Issue number5
DOIs
Publication statusPublished - 22 May 2013

Keywords

  • Magnetic shielding
  • partial element equivalent circuit (PEEC)
  • plate
  • symmetry

ASJC Scopus subject areas

  • Electrical and Electronic Engineering
  • Electronic, Optical and Magnetic Materials

Cite this