Numerical and experimental investigation on flow and mixing in batch-mode centrifugal microfluidics

Yong Ren, Woon Fong Leung

Research output: Journal article publicationJournal articleAcademic researchpeer-review

21 Citations (Scopus)

Abstract

The vortical flow leading to mixing in micro-chamber due to Euler/inertial force from continuous cyclic acceleration-and-deceleration under unidirectional rotation has been investigated both numerically and experimentally. The primary vortex as seen from numerical model during acceleration was confirmed by flow visualization by monitoring the motion of the interface between two miscible dyed liquids, and by tracking the movement of neutrally buoyant particles in the flow. In a typical test, a total of 15 cycles (equivalent to 150 s) was required to achieve uniform mixing by continuously angular acceleration-and- deceleration. This is much shorter when compared to mixing of liquids by molecular diffusion for the same test geometry (stationary) which took at least 2400 s to reach uniform mixture. For practical application, the effectiveness of mixing is quantified by a specific mixing time (SMT), which corresponds to the time for mixing quality, α, to reach 90% normalized by the volume of the mixture in the chamber. Lower SMT is indicative of more effective mixing. SMT was found to decrease with increasing (a) outer radius, (b) angular span, and (c) acceleration/deceleration as a result of stronger vortical flow. For small angular span (i.e. 5°) wherein mixing is slow, increasing acceleration from 17 to 34 rad/s2can compensate mixing, whereas for larger angular span (i.e. 20°) this is not as significant as mixing is already quite effective. Experimental measurements on SMT agree well with those of the numerical model.
Original languageEnglish
Pages (from-to)95-104
Number of pages10
JournalInternational Journal of Heat and Mass Transfer
Volume60
Issue number1
DOIs
Publication statusPublished - 4 Feb 2013

Keywords

  • Centrifugal microfluidics
  • Lab-on-a-chip
  • Mixing
  • Primary vortex
  • Specific mixing time
  • Vortical flow

ASJC Scopus subject areas

  • Condensed Matter Physics
  • Mechanical Engineering
  • Fluid Flow and Transfer Processes

Cite this